GENERAL:
ArChine Comptek FPC 32 is custom-blended with synthetic base fluids and special additives to provide excellent protection against wear and outstanding cold-temperature fluidity. It offers excellent performance in a wide range of temperatures including sub-zero temperatures. It also offers excellent water separation as well as rust, corrosion, deposit and water-washout resistance to protect components. In addition, it resists fling-off and is designed to remain on the chain for maximum lubrication and protection.
ArChine Comptek FPC 32 is long life lubricant and recommended for use in screw compressors, evaporators and spiral freezers operating at extremely low temperatures including cryogenic-freezing temperatures.
ArChine Comptek FPC 32 meets USDA H-1 requirements for incidental food contact and complies with requirements for FDA 21 CFR 178.3570.
ATTRIBUTES
Very high viscosity index for enhanced lubrication and superior protection at low temperatures
Excellent film strength and anti-wear properties
Outstanding cold-temperature fluidity
Resists fling-off and remains on the chain for maximum lubrication and protection
High stability and demulsibility in wet environments
Excellent rust, corrosion and deposit resistance
Non-toxic/non-hazardous
Applications
The following types of compressor applications have shown excellent performance with the ArChine Comptek FPC 32 oil:
Primarily recommended for rotary screw and vane air compressor
Very effective in screw type compressors with oil injection cooling
Units operating under severe conditions
Multistage units with a history of excessive oil degradation from mineral oil-based products
Compressor systems with critical gears and bearings
Compressors used in stationary and mobile applications
For spiral freezers operating at extremely low temperatures including cryogenic-freezing temperatures
TYPICAL PROPERTIES*:
|
Appearance |
Yellow, transparent liquid |
|
Density@ 20℃, g/cm3 |
0.838 |
|
Viscosity @ 40℃, mm2/s |
30.5 |
|
Viscosity @ 100℃, mm2/s |
5.53 |
|
Viscosity Index |
120 |
|
Pour Point, ℃ |
-51 |
|
Flash Point, ℃（open cup） |
232 |
Foaming 24℃,
93.5℃,
after24℃ |
10/0
20/0
10/0 |
|
Copper corrosion,100℃/3hr, grade |
1b |
|
Online1
Online1